close
close

Jeep Cherokee Remote Start Not Working

Jeep Cherokee Remote Start Not Working. Wk1 troubleshooting / problems discussion / dealer. It is not the batteries in the remote.

Jeep Cherokee Remote Start Not Working Hfsatx from at27.hfsatx.com

Wk1 troubleshooting / problems discussion / dealer. When the key fob is dead, there is a chip inside of it that can still read with the car's computer module, so you can start your car. I checked the hood switch and that seems to be working ok.

Read Somewhere That If That Is Not Depressing Fully The Remote Does Not Work.

We replaced the coil and the problem was fixed. When i leave the car and the key fob is still in vehicle it states that. I have a 2014 jeep grand cherokee and the key fobs don't always work.

The Jeep Dealer Says That I'll Need A $500.

I did disconnect the main battery to check voltage on aux battery, it was 11.7. It is not the batteries in the remote. Does not matter if i use the fob or the app to remote start.

To Try To Troubleshoot, Have Tried To Remote Start When Within Visual Range.

The rest of the fob works fine, but all the same, i installed a new fob battery, no change. When the key fob is dead, there is a chip inside of it that can still read with the car's computer module, so you can start your car. Also checked to see if it would start the jeep from inside on just the aux battery, it would not.

When I Open The Door With The Key The Alarm Always Goes Off And Takes A Few Minutes For It To Stop.

Remote start abort message the following messages will display in the evic if the vehicle fails to remote start or exits remote start prematurely: Outside temps don't seem to be a factor. Turn the key to the run position and aim the keyless remote at the steering wheel.

Wk1 Troubleshooting / Problems Discussion / Dealer.

Turns out the cel was caused by a faulty coil. Check the sensor on the underside of the hood. Average failure mileage is 80,000 miles.

Leave a Reply

Your email address will not be published.