close
close

Yealink Phone Setup Guide

Yealink Phone Setup Guide. Connect the network and power. Enter the default password (admin)

Yealink SIPT21 User Manual 2 pages Also for SIPT21P from www.manualsdir.com

Press the save soft key to accept the. This guide provides the steps to correctly setup and provision a yealink ip phone. Setup instructions, pairing guide, and how to reset.

Enter The Number, And Then Tap Ok Or The Send Soft Key.

This guide provides the steps to correctly setup and provision a yealink ip phone. Select settings (option 2) select basic settings (option 1) select display (option 3) sound settings. User manual instruction guide for dect ip phone w53h yealink (xiamen ) network technology co., ltd.

This Doesn’t Take Long As It Is Easy To Do.

Enter the number, and then tap ok or the send soft key. If you find anything missing, contact your system administrator. Connect the dc plug on the power adapter to the dc port on the phone and connect the other end of the power adapter into an electrical power outlet.

You Must First Set Up Your Phone Before You Can Use It.

Check your hub or switch is up to ieee 802.3af standards ii. The network cable from the wall (typically a gray cable) will connect to the back of the phone. Attach the stand, as shown below:

Press The Add Soft Key To Add A Contact.

Applies to firmware version 45.80.0.1 or later. Update the backlight and contrast settings on your phone by following these instructions: Configuring a yealink t32g, t38g, t42g, t46g ip phone to register with 3cx.

Just Follow The Simple Instructions In This User Guide Or The Quick Start Guide Included With The Phone.

Connect the ethernet cable between the internet port on the phone and the network port on a router or switch to access lan. When provisioning a yealink phone manually, there are two methods. Connect the handset and optional headset, as shown below:

Leave a Reply

Your email address will not be published.